When your stamps are too big for a standard pad, the Trodat 9053 has the room you need. Its large 90 x 160 mm pad takes stamps up to 160 x 90 mm – ideal for wide address and company stamps, logo stamps, receiving and inspection stamps, and large wooden-handle rubber stamps used in offices, warehouses, schools and craft work. Pre-inked versions give Trodat's best stamp impressions: sharp contours and full, even coverage across the whole stamp surface, for thousands of clean prints. The water-based ink meets the indelibility requirements of DIN ISO 14145-2, so stamped documents stay legible for decades. The hygroscopic ink draws moisture from the air, so the pad refreshes itself and stays ready to use in all climate conditions. Despite its size, the pad is designed for practical one-hand operation, and a colour marking on the lid shows the ink colour at a glance. The case is made from at least 95% recycled plastic. When the pad starts to fade, re-ink it with Trodat 7011 stamp ink in the same colour. Also available as a dry (uninked) version with a robust felt pad that you can ink yourself – for example with solvent-based or oil-based special inks. Features: - Large stamp pad for hand stamps and wooden-handle rubber stamps - Pad size 90 x 160 mm – for stamps up to 160 x 90 mm - Pre-inked with indelible water-based Trodat ink (DIN ISO 14145-2) - Sharp, even impressions across large stamp surfaces - Hygroscopic ink – always ready to use, in all climates - Practical one-hand operation - Colour marking on the lid - Case made from at least 95% recycled plastic - Re-inkable with Trodat 7011 stamp ink - Also available as a dry felt pad for special inks Technical details: - Model: Trodat 9053 - Pad size: 90 x 160 mm - Max. stamp size: 160 x 90 mm - Weight: approx. 130 g - Ink colours: black, red, blue, green, violet, or dry (uninked) - Ink type: water-based, indelible (DIN ISO 14145-2) - Refill ink: Trodat 7011 - Manufacturer: Trodat GmbH, Austria